Sistema de automação utilizando redes Mesh e Ad Hoc para área industrial

Lucas H. Santos; Eduardo J. da Silva; Marinelson P. de Santana; Lucas R. Morais; Elen P. Lobato; Wellington S. Fonseca; Marcelo de O. e Silva

doi:10.20906/CBA2022/3712

Lucas H. Santos Universidade Federal do Pará (UFPA), Belém
Eduardo J. da Silva Universidade Federal do Pará (UFPA), Belém
Marinelson P. de Santana Universidade Federal do Pará (UFPA), Belém
Lucas R. Morais Universidade Federal do Pará (UFPA), Belém
Elen P. Lobato Programa de Pós-Graduação em Engenharia Elétrica (PPGEE), UFPA, Belém
Wellington S. Fonseca Programa de Pós-Graduação em Engenharia Elétrica (PPGEE), UFPA, Belém
Marcelo de O. e Silva Programa de Pós-Graduação em Engenharia Mecânica (PPGEM), UFPA, Belém

DOI: https://doi.org/10.20906/CBA2022/3712

Keywords: Ad Hoc, ESP-Now, ESP32, Mesh network, engine, MQTT

Abstract

This paper describes the implementation of an engine automation system that uses ESP-NOW and MQTT (Message Queue Telemetry Transport) protocols to send data. The main objective of the system created is to avoid data loss due to eventual failures in the communication network. To this end, the system developed has the ability to use two network topologies: Mesh and Ad Hoc. As a way to verify its operation, tests were performed, where the implemented system was allocated to control an exhaustion system, a compression system, and a water level control system. After the tests carried out, it was found that the system achieved its main objective and its use in production lines in the industrial sector is feasible.